MapForums
Community of VE/MapPoint Users and Developers
Avoiding Low Weight Bridges
This is a discussion on Avoiding Low Weight Bridges within the MapPoint 2006/2009 Discussion forums, part of the Map Forums category; I am tring to avoid the low weight bridges in a tri-county area for the Department of Transportation and when ...
| |||||||
| Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
05-04-2006
| |||
| |||
| Avoiding Low Weight Bridges         |
|
05-04-2006
| ||||
| ||||
|
The Avoid Area functionality only works on road junctions. So if there's a low weight bridge, you need to avoid the entire road segment - ie. the Avoid Area has to cover one or both road junctions at either end. Yes this can be difficult, for example it is perfectly legitimate in the real world, for your heavy truck to pass through one of those junctions, but not turn on to the road with the restricted bridge. The above solution would also stop these routes. Richard
__________________ Winwaed Software Technology LLC http://www.winwaed.com See http://www.mapping-tools.com for MapPoint Tools Pre-Order MapPoint 2009 today: http://www.mapping-tools.com/mappoint2009 |
 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
| ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| make a road (or 2-3) by calculating the total weight | DavidofMontreal | MapPoint 2006/2009 Discussion | 1 | 06-22-2004 07:19 AM |
| I know of at least 2 missing roads or bridges in m.... | Anonymous | MapPoint 2006/2009 Discussion | 1 | 07-03-2002 10:23 AM |
All times are GMT -5. The time now is 12:48 AM.
