MapForums
Community of VE/MapPoint Users and Developers
Can't optimize route in Wyoming???
This is a discussion on Can't optimize route in Wyoming??? within the MapPoint 2006/2009 Discussion forums, part of the Map Forums category; Hello All, I am not able to optimize a route with about 140 addresses in the state of WY. I ...
| |||||||
| Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
11-07-2007
| |||
| |||
 Can't optimize route in Wyoming??? I am not able to optimize a route with about 140 addresses in the state of WY. I have never had this problem before. I imported the addresses from my excel database as usual. All the locations show up on the map, but going to optimize, I get error telling me that the first location can not be routed to due to no road accessing the location. I have gone as far as deleting the first handfull of addresses, and I get the same error. Any ideas would be greatly appreciated... CB         |
|
11-08-2007
| ||||
| ||||
| Re: Can't optimize route in Wyoming???
I think you need to loop over and test each stop to see if it's routable. I kept having this problem in Florida where there are lots of canals or whatever they call them down there. However there may still be some problems with Optimization - even when all stops are routable. I think this occurs when there are dead-end one way streets. So - no good solution except to do some programming to help find which stop or stops are causing the problem and remove or adjust it or them. Eric
__________________ |
|
11-08-2007
| |||
| |||
| Re: Can't optimize route in Wyoming???
Thanks for the advice. After going through each of the 140 stops (one by one) I was able to locate a stinker sitting on a fork in the road! I moved it up a block and all worked well! Again, thanks. CB |
|
11-08-2007
| ||||
| ||||
| Re: Can't optimize route in Wyoming???
What a pain, but glad you solved it. I remember having problems with dead end streets that were one way - imagine hesitation of the person having to do a delivery to such a location - once you go in you can't come out! Or having to work at a location like that.  Eric
__________________ |
 |
« Need Help Running MapPoint 2006 via Limited User Account
|
Remove cities and use two letter state abbreviations »
| ||||
| Posted By | For | Type | Date | |
| Snap to a Road - MapPoint Articles - MP2K Magazine | This thread | Refback | 11-09-2007 10:15 AM | |
| Microsoft MapPoint 2006 - MP2K Magazine | This thread | Refback | 11-08-2007 05:19 AM | |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
| ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Handling Route that Calculates but does not Optimize | Eric Frost | MapPoint 2006/2009 Discussion | 4 | 03-07-2005 02:07 PM |
| Optimize and calculate a Route | rms62 | MapPoint 2006/2009 Discussion | 2 | 08-22-2003 02:55 PM |
| Optimize a Route with Scheduled Time windows | Anonymous | MapPoint 2006/2009 Discussion | 0 | 07-09-2003 06:20 AM |
| Calculate route with Segment preferences vs optimize | David Kachuck | MapPoint 2006/2009 Discussion | 1 | 01-03-2003 03:29 PM |
| Route optimize: shortest vs quickest | David Kachuck | MapPoint 2006/2009 Discussion | 1 | 12-16-2002 07:23 PM |
All times are GMT -5. The time now is 10:43 AM.
