In my routing project we are starting and ending at the same address - when I reverse the route, it swaps "Start" and "End. While they are the same location, when we put it into a GPX file, and then a GPS unit it is starting from the end and is confusing for drivers.

So, my question is, how can I programmatically reverse the route and then swap the start and end points and recalculate the route? I looked at moving waypoints in the help file, but you never know how many stops will be in a particular route.

Jim

Well, I think i found a workaround... I just renamed the stops.

A great. Thanks for follow up